100字范文,内容丰富有趣,生活中的好帮手!
100字范文 > 气-液两相流 gas-liquid two-phase flow英语短句 例句大全

气-液两相流 gas-liquid two-phase flow英语短句 例句大全

时间:2020-09-16 16:35:19

相关推荐

气-液两相流 gas-liquid two-phase flow英语短句 例句大全

气-液两相流,gas-liquid two-phase flow

1)gas-liquid two-phase flow气-液两相流

1.Study on the characteristics of the fluctuating pressure forgas-liquid two-phase flow across the circular cylinder surface;气-液两相流横掠圆柱表面脉动压力特性的研究

2.Its basic principle is that there is a quite steady flow state of annular flow in the flow pattern ofgas-liquid two-phase flow.模型是建立在压力能量消耗率最小的原理上的,其基本原理是:在气-液两相流的流型中,环状流具有相当稳定的流动状态。

英文短句/例句

1.Numerical Investigation on Gas-Liquid Flow and Heat Transfer Characteristics in a Liquid-Reactor溶液堆内气-液两相流流动及换热特性数值研究

2.Research on drift-flux model for gas-liquid two-phase flow in horizontal wellbore水平井筒中气-液两相流漂移模型研究

3.Accurate Measurement of Liquid Phase Volumetric Fraction in Gas/Liquid Two phase Flow气液两相流液相体积含量的精确测量

4.Research on the Supersonic Two Phase Flow Liquefaction Equipment超声速气液两相流液化升压装置研究

5.Study on pressure drop models of gas-liquid two-phase pipe flow in gas reservoir产水气藏气液两相管流动态规律研究

6.Study on Soft Measurement Method of Gas/Liquid Two-Phase Flow Parameters;气液两相流流动参数软测量方法研究

7.High gas liquid ratio vertical two-phase pipe low flow pattern distinetion of study高气液比垂直两相管流流型判别研究

8.Cross-correlation velocity measurement of gas-liquid two-phase flow based on void fraction基于截面含气率的气/液两相流相关速度测量

9.CFD Simulation of Gas-Liquid Flow in Bubble Column with Two-bubble Phase Population Balance Model双气泡相群平衡模型模拟鼓泡塔气液两相流

10.Study on Parameters Measurement of Gas-liquid Two-phase Flow Based on LS-SVM;基于LS-SVM的气液两相流参数测量研究

11.Effect of Rolling Condition on Two-phase Flow Pattern in Vertical Tubes;摇摆对竖直管内气液两相流型的影响

putational Fluid Dynamics(CFD) Study on Liquid-Gas Two Phase in Feed Distributor;进料分布器气液两相流场的CFD研究

13.Numerical Simulation and Experimental Study of Gas-liquid Two-phase Cross Flow;气液两相绕流的数值模拟及实验研究

14.Flow Characteristics of Gas-liquid Two-phase Flow in Small Square Channel;正方形小通道内气—液两相流动特性

15.CFD Simulation of Two Phases Flow in Bubble Column;鼓泡塔内气液两相流动的CFD模拟

16.Dynamic Simulation Study of Gas-Liquid Two-Phase Flow for Underbalanced Drilling欠平衡钻井气液两相流动态模拟研究

17.Analysis of factors impacting bubbly flows through converging-diverging nozzle喷管中泡状气液两相流影响因素分析

18.Flow pattern and gas-liquid interfacial area in a microchannel contactor微通道气液两相流型及界面面积测定

相关短句/例句

gas-liquid flow气-液两相流

1.Very few numerical simulation researches on thegas-liquid flow in stirred tanks with multiple impellers were reported by using Computational Fluid Dynamics (CFD).目前的研究主要集中在对气-液搅拌槽的实验研究以及单层六直叶涡轮桨搅拌槽的数值模拟上,采用计算流体力学(CFD)方法对多层桨搅拌槽内气-液两相流的数值模拟研究较少。

3)gas liquid two phase flow气-液两相流

4)gas-liquid two-phase flow气液两相流

1.Simulation of effects of hydrophilic properties of channel walls on characteristics ofgas-liquid two-phase flow in anode channel of DMFC;壁面亲水性对DMFC阳极通道内气液两相流影响的数值模拟

2.Numerical simulation ofgas-liquid two-phase flow in aeration basin;曝气池中气液两相流数值模拟

3.Metering characteristics of slotted-orifice forgas-liquid two-phase flow with low liquid fractions;槽式孔板的低含液率气液两相流测量特性

5)gas-liquid flow气液两相流

1.Hydrodynamic characteristics ofgas-liquid flow in an up-flow ejector;上喷式喷射器内气液两相流的流体力学特征

2.Numerical simulation on thegas-liquid flows inside the oil-gas Separators;油气分离器内气液两相流的数值模拟

3.CFD simulation ofgas-liquid flow in bubble column;鼓泡塔反应器气液两相流CFD数值模拟

6)gas/liquid two-phase flow气液两相流

1.Symbolic sequence statistical analysis of differential pressure measurement fluctuating signal ofgas/liquid two-phase flow;气液两相流差压测量波动信号的符号序列统计分析

2.Wigner-Ville analysis of measurement fluctuating signals of conductance sensor ingas/liquid two-phase flow;气液两相流电导传感器测量波动信号的Wigner-Ville分析

3.Study on Analysis Method of Dynamic Fluctuating Signal of Gas/Liquid Two-Phase Flow;气液两相流动态波动信号分析方法研究

延伸阅读

传热学:两相流换热两相流换热:自然界中的物质有3种形态﹕固相﹑液相和气相。两相物质共存的流动称为两相流。两相流与管道壁面之间的传热过程称为两相流换热﹐它实际上也是一种对流换热。在工业生產中﹐有各种各样的两相流和两相流换热。例如﹐在化学工业中的流化床内的流动和换热﹐用管道输送粉状和粒状固相物质时的流动和换热﹐气-液(或汽-液)两相流换热等。其中汽-液两相流换热得到广泛而深入的研究﹐因为它是生產中广为使用的蒸汽锅炉﹑蒸汽冷凝设备和核反应堆中传热计算的重要基础知识。两相流换热已发展成为传热学的一个重要分支。 两相流换热与单相流换热的主要区别在於两相分界面的形状对流型和换热过程有重要影响﹐而相分界面的形状又随著含汽率﹑流速和管道放置的方位等条件的变化而改变。例如对於竖管的两相流传热就有4种流态(见图 竖管内两相流换热示意图 )。泡状流﹕当含汽率不大时﹐在连续液体中均匀分布著许多大小不同的小汽泡。块状流﹕当含汽率增高到某一数值时﹐许多小汽泡就汇集成为一个块状的大汽泡﹐其直径接近管道的内径。在大汽泡之间的液体中含有一些均布的小汽泡。环状液膜流﹕当含汽率增高到很高时﹐液相变成沿管壁流动的环状液膜﹐而汽相则居中流动﹐少量液相以细小雾状液珠悬浮在汽相中。雾状流﹕当管壁上的环状液膜被全部蒸发时﹐管内就充满著悬浮雾滴。 进行两相流换热计算时﹐必须根据不同的流型和含汽率的高低﹐引用相应的经验公式。常见的两相流换热有沸腾换热和凝结换热。

本内容不代表本网观点和政治立场,如有侵犯你的权益请联系我们处理。
网友评论
网友评论仅供其表达个人看法,并不表明网站立场。